Vadovas Zanussi ZHI612G Gartraukis

Vadovas

2

www.zanussi.com

Recommendations

and suggestions

• The Instructions for Use apply

to several versions of this ap-

pliance. Accordingly, you may

nd descriptions of individual

features that do not apply to

your specic appliance.

• The manufacturer will not be

held liable for any damages

resulting from incorrect or im-

proper installation.

• The minimum safety distance

between the cooker top and

the extractor hood is 650 mm

(some models can be installed

at a lower height, please refer

to the paragraphs on working

dimensions and installation).

• Check that the mains voltage

corresponds to that indicated

on the rating plate xed to the

inside of the hood.

• For Class I appliances, check

that the domestic power supply

guarantees adequate earthing.

Connect the extractor to the

exhaust ue through a pipe of

minimum diameter 120 mm.

The route of the ue must be

as short as possible.

• Do not connect the extractor

hood to exhaust ducts carry-

ing combustion fumes (boilers,

replaces, etc.).

• If the extractor is used in

conjunction with non-electrical

appliances (e.g. gas burning

appliances), a sufcient degree

of aeration must be guaranteed

in the room in order to prevent

the backow of exhaust gas.

The kitchen must have an

opening communicating directly

with the open air in order to

guarantee the entry of clean air.

When the cooker hood is used

in conjunction with appliances

supplied with energy other than

electric, the negative pressure

in the room must not exceed

0,04 mbar to prevent fumes

being drawn back into the room

by the cooker hood.

• The air must not be discharged

into a ue that is used for ex-

hausting fumes from appliances

burning gas or other fuels (not

applicable to appliances that

only discharge the air back into

the room).

• In the event of damage to

the power cable, it must be

replaced by the manufacturer

or by the technical service de-

partment, in order to prevent

any risks.

• If the instructions for installation

for the gas hob specify a greater

distance specied above, this

has to be taken into account.

Regulations concerning the

discharge of air have to be

fullled.

• Use only screws and small

parts in support of the hood.

Warning: Failure to install the

screws or xing device in ac-

cordance with these instructions

may result in electrical hazards.

• Connect the hood to the mains

through a two-pole switch hav-

ing a contact gap of at least

3 mm.

EN

Įvertinimas

Daugiau apie šį vadovą

Suprantame, kad puiku turėti popierinį savo Zanussi ZHI612G Gartraukis vadovą. Visada galite atsisiųsti vadovą iš mūsų svetainės ir atsispausdinti patys. Jei norite turėti originalų vadovą, rekomenduojame susisiekti su Zanussi. Jie gali pateikti originalų vadovą. Ar ieškote savo Zanussi ZHI612G Gartraukis vadovo kita kalba? Pasirinkite pageidaujamą kalbą mūsų pagrindiniame puslapyje ir ieškokite modelio numerio, kad pamatytumėte, ar jį turime.

Specifikacijos

Visi Zanussi Gartraukiai vadovai
Daugiau Gartraukiai vadovų

Dažnai užduodami klausimai apie Zanussi ZHI612G Gartraukis

Mūsų palaikymo komanda ieško naudingos informacijos apie produktą ir atsakymų į dažniausiai užduodamus klausimus. Jei dažniausiai užduodamuose klausimuose pastebėjote netikslumų, praneškite mums naudodamiesi mūsų kontaktų forma.

Susiję produktai

Vadovas

Zanussi ZHS92650XA Gartraukis

Vadovas

Zanussi ZFCX17X Gartraukis

Vadovas

Zanussi ZHG512G Gartraukis

Vadovas

Zanussi ZHT611N Gartraukis

Vadovas

Zanussi ZHB92670XA Gartraukis

Vadovas

Zanussi ZFP419X Gartraukis

Vadovas

Zanussi ZHV64450BA Gartraukis

Vadovas

Zanussi ZHC62642XA Gartraukis

Susijusios kategorijos