Vadovas AEG X86464BV01 Gartraukis

Vadovas

3

ENGLISH

1. RECOMMENDATIONS

AND SUGGESTIONS

• The Instructions for Use apply

to several versions of this ap-

pliance. Accordingly, you may

nd descriptions of individual

features that do not apply to

your specic appliance.

• The manufacturer will not be

held liable for any damages

resulting from incorrect or

improper installation.

• The minimum safety distance

between the cooker top and

the extractor hood is 650 mm

(some models can be installed

at a lower height, please refer

to the paragraphs on working

dimensions and installation).

• Check that the mains voltage

corresponds to that indicated

on the rating plate xed to the

inside of the hood.

• For Class I appliances, check

that the domestic power supply

guarantees adequate earthing.

Connect the extractor to the

exhaust ue through a pipe of

minimum diameter 120 mm.

The route of the ue must be

as short as possible.

• Do not connect the extractor

hood to exhaust ducts carry-

ing combustion fumes (boilers,

replaces, etc.).

• If the extractor is used in

conjunction with non-electrical

appliances (e.g. gas burn-

ing appliances), a sufcient

degree of aeration must be

guaranteed in the room in or-

der to prevent the backow of

exhaust gas. The kitchen must

have an opening communicat-

ing directly with the open air in

order to guarantee the entry

of clean air. When the cooker

hood is used in conjunction

with appliances supplied with

energy other than electric,

the negative pressure in the

room must not exceed 0,04

mbar to prevent fumes being

drawn back into the room by

the cooker hood.

• In the event of damage to

the power cable, it must be

replaced by the manufacturer

or by the technical service de-

partment, in order to prevent

any risks.

• If the instructions for installa-

tion for the gas hob specify

a greater distance specied

above, this has to be taken

into account. Regulations

concerning the discharge of

air have to be fullled.

• Use only screws and small

parts in support of the hood.

Warning: Failure to install

the screws or xing device in

accordance with these instruc-

tions may result in electrical

hazards.

• Connect the hood to the mains

through a two-pole switch hav-

ing a contact gap of at least

3 mm.

2. USE

• The extractor hood has been

designed exclusively for do-

Įvertinimas

Daugiau apie šį vadovą

Suprantame, kad puiku turėti popierinį savo AEG X86464BV01 Gartraukis vadovą. Visada galite atsisiųsti vadovą iš mūsų svetainės ir atsispausdinti patys. Jei norite turėti originalų vadovą, rekomenduojame susisiekti su AEG. Jie gali pateikti originalų vadovą. Ar ieškote savo AEG X86464BV01 Gartraukis vadovo kita kalba? Pasirinkite pageidaujamą kalbą mūsų pagrindiniame puslapyje ir ieškokite modelio numerio, kad pamatytumėte, ar jį turime.

Specifikacijos

Visi AEG Gartraukiai vadovai
Daugiau Gartraukiai vadovų

Dažnai užduodami klausimai apie AEG X86464BV01 Gartraukis

Mūsų palaikymo komanda ieško naudingos informacijos apie produktą ir atsakymų į dažniausiai užduodamus klausimus. Jei dažniausiai užduodamuose klausimuose pastebėjote netikslumų, praneškite mums naudodamiesi mūsų kontaktų forma.

Susiję produktai

Vadovas

AEG DPE5660M Gartraukis

Vadovas

AEG DF4160-ML Gartraukis

Vadovas

AEG X69453MV0 Gartraukis

Vadovas

AEG DL7275-M9 Gartraukis

Vadovas

AEG DI9966-M Gartraukis

Vadovas

AEG DBE5670R Gartraukis

Vadovas

AEG X69453MD02 Gartraukis

Vadovas

AEG ADU6200AB Gartraukis

Susijusios kategorijos